POE Power Draw Specs

Owned by Mike Hart
May 11, 2022
1 min read

iT100 model tested was fully optioned iT100-AMT with AMP and Thermal modules to demonstrate the expected maximum wattage consumption for the device. 

IrisID advises not designing POE wattage for anything lower than these readings even though actual model/device used may consume less.  Suggested allocations for each iT100 are minimum 17 watts of power which will compensate for any degradation implied by wire length from switch to iT100.

Readings in various modes:

Mode

VDC

AMPS

Watts

Mode

VDC

AMPS

Watts

During Capture (Iris, Face, Card, Thermal)

53.4

0.320

16.0

Bootup

53.4

0.150

8.0

Standby (continuous mode – static wallpaper)

53.4

0.205

10.0

Standby (continuous mode – movie wallpaper)

53.4

0.220

11.75

Peak Draw

53.5

0.310

16.6

Average

53.42

0.237

12.47

Â